5

I've just finished my first brew (brown ale), and the results aren't quite as spectacular as I had hoped. The issue is a prominent, yet not overpowering, sweet almost caramel-like flavor. As best I can tell, the culprit is Diacetyl.

However, being such a novice, I can't be certain that diacetyl is my issue let alone identify its origin. I have a few questions:

  1. Do other contaminates or impurities produce similar flavors?
  2. Now that the beer has been bottled, is there anything I can still do to mitigate these flavors?
  3. Is this the result of racking too early? If not, what are other possible causes?

For #3, my beer sat in the primary fermenter for about 6 days before being transferred. The fermenter was producing virtually no gases for about 24 hours prior to transferring. I've read enough to now understand I need a hydrometer to judge properly, but is it likely I transferred too early? Is the source of my troubles?

Thanks!

2 Answers 2

6

"Sweet almost caramel-like flavor" doesn't sound like diacetyl to me. Diacetyl is "buttery," and is hard to get in normal Ale fermentations unless you are using a yeast strain known for it. (Ringwood, I think is noted for it?) What yeast did you use, and at what temps?

I would attribute "sweet/caramel" flavors in your first batch to more likely be "extract twang," a common flavor you get when using a little too much crystal and the beer just isn't dry enough. I'm assuming this is an extract batch, of course. If you post your recipe, that would help as well.

Also, for future reference, the current homebrewing wisdom is that it is best to NOT rack to secondary for at least 2-3 weeks, if you even rack at all. I would not feel good about racking a beer after 6 days, that's just to early. I can't think of a single type of beer that I'd rack so quick. On your next batch, unless it has fruit or lots of dry hops, I'd suggest that you skip the secondary altogether. Just ferment for 3 weeks in the primary before bottling.

6
  • I was thinking the same, as well as low attenuation. Cooper's yeast, by any chance? I've had that poop out at 1.020 several times when I was doing extract, ending up with a very sweet/caramel-y beer.
    – JoeFish
    Jan 10, 2012 at 14:36
  • Thanks. I'll post my recipe soon, but I think you're probably right. Diacetyl was the closest flavor I found mentioned, but the flavor is also very reminiscent of my extract's aroma. As for racking, my father (also a brewer) never racks and found the notion odd. I however was adamant about following the recipe sheet provided by my LHBS, which recommended racking to a secondary at around six days.
    – Colin
    Jan 10, 2012 at 16:46
  • Looks like the yeast was Safale 05
    – Colin
    Jan 10, 2012 at 16:54
  • Yeah I think US-05 would only throw diacetyl if you fermented it at like 50F and cold crashed it before it was done. Now throw away that recipe sheet and listen to your father!
    – GHP
    Jan 10, 2012 at 17:58
  • 1
    Yes, twangy flavors do tend to mellow out in the bottle as the beer ages. Your beer will continue to improve greatly over the first 6-10 weeks in the bottle. It will then likely be at its peak, so don't drink too many now. When did you bottle?
    – GHP
    Jan 13, 2012 at 14:41
2

A couple of follow up questions:

1.) as the poster above says, the recipe would help. Sometimes it is difficult for yeast to metabolize the some of the sugars in extract syrups that haven't been fully converted to consumable monosaccharides.

2.) Just a thought: did you add your extract to your water when your heat source was fired? That can cause carmelization (maillard reaction) of the sugars in the extract syrups and complicate/prevent the yeast's metabolization of them.

3.) You absolutely, unequivocally need a hydrometer and some sort of sample thief to pull samples (a santized, decent-sized turkey baster will work in a pinch). Otherwise, you have no way of knowing if the beer is finished.

4.) As the above poster said, I have learned to leave brews in the primary for a minimum of 2-3 weeks, usually no more than 4. Even when those beautiful, smile-inducing airlock bubbles stop, the yeast is still working to make your beer better, primarily by cleaning up some other waste products, including, but not limited to diacetyl. 6 days is not a long time.

5.) Is the beer undrinkable (loaded question)? My first brew (imperial blonde) was a tad on the sweeter side, but both my fiancee and I loved drinking it. If its ok but not your favorite, I would keep it around, and it could mature some more in the bottles. It is still a pretty 'green' beer and would benefit from some additional maturation.

Here's my best suggestion:

If this beer is in the bottles, not a whole lot you can do without some major brain damage, equipment and risk of infection. I know you probably have the itch to brew about 10 different styles at this point, but I would buy the exact same kit (and a hydrometer), exact same brewday practices, but this time leave it in the primary for 21 days then rack/prime/bottle. In 5-6 weeks, you can taste the two side by side and taste the difference. If you really need to get another style under your belt, buy another ale pail and another kit. IMHO, you (and your palette) have the opportunity to learn an invaluable lesson from this experience.

Let us know how it turns out!

2
  • +1 for smile-inducing airlock bubbles. That induced a smile of its own :)
    – JoeFish
    Jan 10, 2012 at 16:27
  • Thanks for the solid advice. The brew is drinkable, some find the flavor almost unnoticeable, but I'm not terribly fond of it.
    – Colin
    Jan 10, 2012 at 16:51

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.