4

My last few all-grain batches have been under the expected OG at least as far as the recipe is concerned. The beers still taste good and all, but I'd like to get my efficiency up.

For example, my last one I really undershot. The recipe looks like it should have been in the 1.070 range, but I only got 1.050.

I'm doing single infusion & batch sparge for my mash.

I am hitting my mash temperatures pretty well (though I want to continue improving this).

What can I look into to get my efficiency up? Where am I losing sugar?

2 Answers 2

6

Two most prevalent issues for poor efficiency when batch sparging are 1) grain crush and 2) void volume in the tun.

1) Take a real close look at your crush. Crush it twice if necessary. If you are getting your grain pre crushed through a mail order, I'd invest in a mill and start doing it at home. My LHBS has a mill that is fixed to a certain gap. Through experience, if I think the grain is not crushed enough, I'll put it through twice and tell the guys its time to tune up the mill. Find some fellow brewers that do all grain and see if you can see their crush so you can compare it to yours.

2) If you put say 4 gallon of water in your mash tun and drain it, you should get close to 4 gallons out, say +/- a quart or so. If you get significantly less that's sugar you can't pull out of the tun no matter what you do. So how your manifold or valve (if you are using a braid) sits near the bottom of the tun can have a big impact. 1050 vs 1070 is a ~28% difference pretty big (so I'd suspect crush vs this issue). From 4 gallons or wort as an example that would be like leaving more than 4 quarts in the mash. This is the only time that mash tun geometry comes into play in a batch sparge set-up. You need to shoot for an 85-90% drain of the tun with just water.

2
  • Hm, I think it could be geometry then because I had to add some water to the boil to get the right amount of wort for the boil. I would think if I added 4 gallons of strike water, the grains would soak up more than just one quart? I know in the case of this brew, it soaked up significantly more than 1 qt.. maybe like you say, closer to a gallon. So I guess I need to find a way to leave less in the mashtun. What would suggest I look at?
    – SimonH
    Jun 7, 2011 at 0:27
  • I normally assume a 10% absorption. So for 4 gallons we're talking closer to 2 quarts (1.6 if you are really anal). I think measuring and tracking volumes is one of those oft overlooked but very important parts of the brewing process. First do the water test and see how much you leave behind in a grain-less tun. Then you'll know if you have a geometry issue.
    – brewchez
    Jun 7, 2011 at 12:57
1

Great answer from brewchez. The other thing to consider (after the 2 he mentioned) is your water. If the pH is way off it can affect conversion. But crush is always the first place to look. One other thing to consider is the source of the recipes. Maybe they're written for higher efficiency than your system gets. You should always adjust any recipe to your own efficiency.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.