2

For mashing, I have kettle and steel grain basket. Heat is provided via a gas stove. I heat the water to a few degrees above mash-in temperature and then ease in the grain basket.

When I measure temperature of my mash I find there is temperature variance between the bottom, middle and the top of the grain basket. It varies by a good five to six degrees between the top and bottom of the basket

Now, if I have to measure the temperature of the mash while attempting to do a step mash, from where should I be measuring the temperature (bottom, middle, top) ? Or do I stir the mash until it is consistent through out and only then consider measuring the temperature?

1

I use a combination of averaging, stirring and recirculating. My mashtun has a large open area under the false bottom. I drain some hot wort off the bottom and add it to the top of the grain bed - - -> then stir- - - > then average.

If you don't have a drain valve, you could raise and lower the grain basket a bit to even out the temperature, then stir. 5-6 degrees F variation isn't too bad as long the average is near the middle of the 145F to 158F mashing range. Keep brewing, you'll sort out your methods!

5-6 C is quite a lot. You could remove 1/3 of the hot water from the kettle, then add the grain, then add the remaining hot water to the top of the grain basket. then stir. I do that in my mashtun to make the mixing easier. Seems to help.

1
  • Uhm when I say 5-6 degrees, I meant °C. I think that's a lot.
    – Rishabh
    Jun 30 at 13:58
1

Measure in 2 or 3 places, then take the average. Works well for me.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.