1
vote
1answer
95 views

Gross layer of foam at the end of fermentation and aging

I experienced few times a gross layer of foam when fermentation finishes. But the beer was fine, no symptoms of contamination neither off-flavors. I never measure the depth of foam but it can have ...
4
votes
1answer
92 views

Over oxygenating

Was reading about oxygenating wort, and the book was saying that the best amount of oxygen ppm is 10. It did say that over oxygenating was sometimes bad, but didn't state how much it took before it ...
1
vote
3answers
2k views

Pitched Yeast at 80-85 deg. Problem?

I pitched English Ale yeast (white labs) around 80 deg, not realizing it was that warm. Relative temp in the room is 68, but wort will not cool down below 80....strange! Its been about 24 hours at ...
1
vote
3answers
2k views

Is 2 hours cooling the wort before adding yeast too long

I forgot about the warmer tap water and found my wort was way too hot and even after adding ice and standing the fermenter in ice water it took nearly two hours before is was the right temperature so ...
5
votes
7answers
752 views

Chilling wort before pitching yeast

I know it is important to chill wort to <80 before pitching yeast, and that quality of final beer is affected by the speed with which the wort was chilled to this point, and there are various ...
4
votes
1answer
133 views

Would you trust this starter?

I had one WLP001 vial of yeast that was only 14 days past its "best buy" date. I made a starter on a stir plate 2 full days before brewing. I got good growth as estimated by an increase in creamy ...