3
votes
2answers
553 views

Potential causes of unreliable pre-boil gravity measurement

I usually take a hydrometer reading immediately after sparge so that I can calculate total points of gravity (i.e. gravity reading * volume), and from there calculate what volume of wort I should ...
8
votes
6answers
7k views

How to strain wort before primary fermentation

I recently made a big beer (Dogfish Head 90 minute clone) with an OG around 1.11. I had never tried to strain wort before moving to a primary fermenter but thought it would be a good idea since this ...
14
votes
4answers
4k views

How to Properly Oxygenate Wort

How much oxygen do I need to put into my wort? I've heard that homebrewers need to aerate with an oxygen stone and either aquarium pumps or oxygen. Is this true, or is shaking my carboy enough to ...
6
votes
2answers
212 views

Homebrewing: Decoction Mashing

Many beers, especially German, are produced with a method called decoction mash. In that, the rising of mash temperature is achieved each time by talking a portion of the MASH, boiling it, and adding ...
4
votes
1answer
133 views

Would you trust this starter?

I had one WLP001 vial of yeast that was only 14 days past its "best buy" date. I made a starter on a stir plate 2 full days before brewing. I got good growth as estimated by an increase in creamy ...
1
vote
1answer
5k views

What is a grant?

How is it used? What does it do?
5
votes
2answers
859 views

What is cold steeping?

What is cold steeping specialty grains all about? How do I do it? What does 'cold' really mean? How long does it take? Advantages and disadvantages?
6
votes
2answers
1k views

Kettle volume measurements

Eventually there comes a time where just boiling 6 gallons for 60 minutes and taking it on faith that you have 5 gallons left doesn't cut it anymore. What tools can I use to measure the volume in the ...
4
votes
3answers
2k views

Are Sparge Arms Necessary

Do you really need a sprinkler of some sort to sparge? Does it really improve the lautering process? How fancy does a sparge arm need to be, does it really have to rotate or can it just sprinkle all ...
5
votes
1answer
854 views

Cleaner wort out of the Kettle

What are the benefits of completely seperating hot debris, hot break and cold break from the wort? Getting these things out of the wort and putting nothing but clean and clear wort in the fermentor ...
9
votes
2answers
998 views

Steeping Specialty Grains

What is the proper procedure for steeping specialty grains while extract brewing? Temp, time, grain bags or not.
5
votes
3answers
2k views

Remedy for a Stuck sparge

How do you fix a stuck sparge? Are there any tricks too getting a sparge running again when it slows to a trick or even stops completely? (This is not intended to be a "how to prevent" the stuck ...
16
votes
1answer
1k views

Partial vs. Full Voume Wort Boil

The starting postion for most new extract brewers is to use a partial boil set up. Defined as using a pot smaller than the intended batch size, all the ingredients are boiled in a smaller volume. ...