1
vote
1answer
28 views

How does the attenuation limit from mash temperature affect yeast attenuation?

Like, for example, if you select a yeast with an average attenuation of 80%, but you mash at 160, which limits attenuation to 76.8%1, would the limit simply be the lower of the limit or the average ...
2
votes
5answers
119 views

What is the proper way to maintain temperature in a water cooler Mash tun by adding hot water?

I bought the 10 gallon water cooler from Home Depot. The hole in it is about 3/4" diamater. After discovering that Home Depot, Lowes, Ace Hardware, and etc. did not sell all the components (hose ...
4
votes
3answers
244 views

Do I need to continuously measure the temperature of my mash tun?

From what I understand, the all-grain brewer warms up water to a particular temperature (usually 10-15*F over the strike temperature), adds this warm water to the grains in a mash tun, in an attempt ...
2
votes
1answer
191 views

Does temperature rise time between mash steps matter?

When doing a multi-step mash, does the amount of time you take in between steps to raise the temperature make a difference? (Aside from the obvious "taking longer will make your brew day take ...
4
votes
2answers
251 views

Effect of decreasing mash temp?

Let's say I mash in at 65 C and over an hour it drops to 60 C - will this have a detrimental effect on my brew?
4
votes
2answers
1k views

Is this a stuck fermentation or did I screw up the mash?

So, a little under a week ago, I brewed a goodly sized stout (1.069 OG) and when I mashed it I ended up missing my mash temp by about 4 degrees. (I was aiming for 158 and ended up with about 162-163.) ...
1
vote
3answers
635 views

overheated the mash by a long shot

I asked before and got some help and have done some reading since. The temp in my mash jumped from 175 to about 195 after I put the lid back on. How much damage did I do? Some things I've read since ...
3
votes
4answers
3k views

Mashing at too High of a Temperature

I did my first all grain batch last night and went way over the desired 150s range on the temperature of my mash. It ended up being around 170f. What effects will there be from mashing at 170 (or ...
4
votes
4answers
1k views

Calculating Amout and Temperature of Water For Mashing

how do you calculate the correct amount and temperature of water and to offset the amount and temperature of the grains? Perhaps there is a formula or rule of thumb that I am missing.
5
votes
3answers
978 views

How do you insulate a cooler based mash tun?

I have a Coleman 70 Quart Xtreme cooler that I've modified for my mash tun. I seem to be losing a lot of heat out the top. Are there any good ways to insulate it to help prevent heat loss?
6
votes
2answers
216 views

Homebrewing: Decoction Mashing

Many beers, especially German, are produced with a method called decoction mash. In that, the rising of mash temperature is achieved each time by talking a portion of the MASH, boiling it, and adding ...
1
vote
2answers
527 views

What's the minimum mash time?

Listening to an episode of Basic Brewing last night, I heard a guest say that most of the conversion in the mash happens in the first half, and that the mash can thus be cut down as short at 45 ...