0
votes
2answers
84 views

Kegging: hose clamp technique?

I'm re-attaching the CO2 to the home made kegerator I've inherited and I'm wondering if there are any steps one should follow for securing the hoses. Securing the hose clamps is pretty obvious, but I ...
0
votes
1answer
48 views

How do I know what value I want for Volumes of CO2

I've bottled about 15-20 batches, but I am ready to keg for the first time. I see the table that has been rep[roduced on quite a few websites, and it has 3 examples with a range for the Volumes of CO2 ...
3
votes
2answers
122 views

Ran out of CO2 while force carbonating

I ran out of CO2 while force carbonating. I barely had enough to seal the lid and purge the air out. I plan on getting more CO2 tomorrow but I'm afraid the beer will absorb the CO2 in the corney keg ...
1
vote
3answers
111 views

Converting hose size from CO2 tank

So I am almost done fermenting my first batch of home brew and am about to start kegging it. The only problem is the current hose coming from the regulator is a good bit wider than the nozzle I have ...
0
votes
2answers
898 views

Aggressive foam from Keg

For the record, I am using some storebought kegs, but figure you guys know more about all of this than I do. EDIT: I checked the internet and the couplers to the keg are of the sanke variety. Here's ...
4
votes
1answer
2k views

Should I leave the CO2 Cylinder connected after force carbonation?

I connected my CO2 Cylinder to my Keg and have it currently force-carbonating. However, it will only be needed next week friday. Should I leave the CO2 Cylinder connected for 8 days at 20psi, or ...
1
vote
1answer
97 views

What is the pressure limit for PVC tubing on barb?

I'm building a spunding valve and can't locate an adapter from female flare to male pipe thread. Until I can, I'm planning on using reinforced PVC tubing to connect the valve/gauge assembly to the gas ...
1
vote
2answers
763 views

Why did beer get into my gas lines from my corny keg?

I think I know the answer to this, but I'd like to see an answer listing more conclusively the different reasons why this happens. Some causes I've seen listed: High pressure plus shaking can cause ...
3
votes
2answers
224 views

Got first 2 kegs and need advice

I just bought two 15.5 gallon kegs yesterday from a local brewery that is closing its doors. They asked for $15 each so there was no way I could pass them up. They are in great condition. I would ...
4
votes
1answer
146 views

Gas line : does it need to be sterilized?

I'm reading websites and I'm viewing videos where people show how to wash kegs, but they never wash their gas line. I was wondering if it's necessary to do so? I'm asking this because I would like to ...
2
votes
3answers
2k views

How do I get CO2 flowing into keg?

I have just kegged my beer and connected the regulator to the CO2 supply. I turn it on and I get no pressure. On my regulator the needle has moved up to the top of the "buy more" zone, but on the ...
5
votes
2answers
539 views

Keg/CO2 question as I think about moving to kegging

This is probably a foolish one, but... So you can force carbonate with a keg (or sugar carbonate, but of course why would you), and then serve from the keg with the CO2 to help dispense. But, if ...