1
vote
2answers
88 views

Can I force carbonate a half-full keg of homemade cola?

I make some small batches of home-made cola, tonic water, and ginger ale - usually making a batch of syrup, then mixing up a corny keg full and force-carbonating it over a few days. Normally I bottle ...
0
votes
1answer
48 views

How do I know what value I want for Volumes of CO2

I've bottled about 15-20 batches, but I am ready to keg for the first time. I see the table that has been rep[roduced on quite a few websites, and it has 3 examples with a range for the Volumes of CO2 ...
3
votes
3answers
306 views

Kegged Beer Not Staying Carbonated

This summer I kegged a pale ale for the first time. For about the first week or so the carbonation level on the beer was great but then the beer started to get flat (still tasted good, just no ...
0
votes
1answer
119 views

Aging full kegs out of fridge - carbonate now or later?

I just bought my first two kegs, and don't yet have a fridge set up for them. Even when I do get my fridge set up I plan to have more kegs than will fit at once. When I fill them is it better to ...
4
votes
2answers
405 views

Transfer flat bottled beer into a keg

Quick rundown. I was in a rush to bottle an IPA and I forgot to add my priming sugar. I remembered after already bottling about three beers and went ahead and got my priming solution going and added ...
2
votes
3answers
186 views

New to Kegging - Help

Just moved to a new house and finally have room for a chest freezer so I can switch from bottling to kegging. I have a johnson digital temp controller to regulate the freezer so I can keep constant ...
0
votes
1answer
2k views

Storing full kegs at room temperature

So I have a related question here, but my questions are the following: I only have one (and only have room for one) dedicated chest freezer/fridge for brewing. I have one beer (Marzen) kegged and ...
1
vote
2answers
764 views

Why did beer get into my gas lines from my corny keg?

I think I know the answer to this, but I'd like to see an answer listing more conclusively the different reasons why this happens. Some causes I've seen listed: High pressure plus shaking can cause ...
2
votes
2answers
469 views

a few questions about using carbonation stones

Just got a carbonation stone because I want to carbonate a keg quickly and have a few questions. Do you need any special tubing to attach the stone to the gas-in dip tube? The stone I have has a ...
4
votes
3answers
1k views

How Long Will a Keg Hold Carbonation if Disconnected from the CO2 Tank?

How long will a keg hold carbonation if it is disconnected from the CO2 tank? Does the type of keg matter?
5
votes
1answer
450 views

Any need to stop yeast before kegging?

I'm brewing to keg for the first time, finally. I am planning to force carbonate and was wondering: Are there was any steps I need to take to stop any active yeast before putting it in the keg and ...
3
votes
2answers
179 views

(Should) my keg floweth over?

So, I kegged my first time (straight from a 3.5wk primary vs 2wk, which I recommend). I tried a little bit of the "force carb", i.e. set to 25-30psi and agitate the keg until I didn't hear any more ...
5
votes
2answers
540 views

Keg/CO2 question as I think about moving to kegging

This is probably a foolish one, but... So you can force carbonate with a keg (or sugar carbonate, but of course why would you), and then serve from the keg with the CO2 to help dispense. But, if ...
6
votes
5answers
22k views

How long do I need to carbonate a keg?

I've recently inherited a keg system from a friend moving interstate and have just dropped my first batch into the keg. I found this chart from a link here that shows CO2 units by pressure & ...
11
votes
3answers
766 views

Is there a way to use my kegging system to carbonate beer for bottling without a beer gun?

The only solutions I've found are expensive, and involved a pricey piece of equipment called a beer gun. Is there a way to carbonate my beer before bottling so I can ensure a good carbonation?
3
votes
2answers
489 views

Letting the gas out of a keg

I'm new to this homebrewing, made a mistake and wondering the consequences of my actions. I have just completed the first week of fermentation and now have moved over to a plastic keg supplied with ...
14
votes
4answers
3k views

How can I avoid a lot of foam in the first pint from the keg?

Whenever I go to get a pint from the keg, the first pint is always foamy. I have to fill the glass up about 1/3 of the way and dump it out, just to the pour actual beer. I usually carbonate by ...
8
votes
3answers
1k views

Is there a quicker way to carbonate a corny keg?

Currently, if I want my beer "today" I put the gas into the out tube at the desired target pressure. I then rest the keg on my lap and gently rock it for about 20 mins, until I don't hear any more ...
2
votes
2answers
572 views

Checking for CO2 leaks

If you have an at home draft system, how do you check for leaks in the CO2 side of the set up? How often do you need to check for leaks?
5
votes
2answers
195 views

Dispensing beers at two different pressures?

I'm working on getting a dual-tap kegerator. Is it worth it to pay the extra to dispense two beers at two different pressures? I can see dispensing a low-carbonation ESB and a high-carbonation ...
9
votes
1answer
702 views

How long does 5lb of C02 last you?

I can never get a grip on how often I'll need to refill my C02. Sometimes it seems to last forever other times it seems very quick. In general, if you are just using C02 to pour, how many soda kegs ...
3
votes
1answer
271 views

force carbonating a scotch heavy ale

I am brewing a scotch ale currently and haven't been able to determine how many volumes of co2 that it should have? also, what pressure should I put the beer under to carbonate to that many volumes. ...
8
votes
4answers
2k views

Will force-carbonated beer remain carbonated if poured into a bottle and capped?

If I pour kegged beer into bottles and immediately cap them to take with me for the evening, will it remain well-carbonated?