Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I just bought two reconditioned 5 gal pin lock kegs. When I filled them up with hot water to clean them out I noticed that the rubber boot at the top of one of them was completely loose - it's only being held on by the poppet valve stems. I plan to remove the poppet valves and try to glue the boot back on... Does anyone know what type of glue would work best?

share|improve this question
    
I'd like to know this too, but for the base of one of my kegs... –  DougEdey May 6 '13 at 3:02
add comment

3 Answers

up vote 1 down vote accepted

Liquid nails or rubber cement would work nicely. Make sure that you remove the 'boot' and remove all of the old residue that may be stuck on. I would probably run some coarse grit sandpaper over that afterwards just to create a rough surface for the cement to bind to. That isn't necessary but make sure you clean the area at least.

share|improve this answer
    
Going to go with the liquid nails...I agree with you that I should clean it well before, but I'm lazy so I'm going to just try squirting it in from every angle and putting something heavy on top for a day or two. If that doesn't work I'll take it apart and do it right. –  Germ May 7 '13 at 2:20
    
Took everything apart (it was easier than I thought it would be), cleaned and sanded the indside of the boot and outside of the keg with 60 grit sand paper, and used an entire syringe of gorilla glue two-part epoxy. I flipped the keg upside down and sat on it to make sure the boot was seated tight and gave it a couple of hours to cure, and it seems to have worked great! Thanks for the help! –  Germ May 10 '13 at 19:46
    
Glad it worked! Just like new. –  TMC May 11 '13 at 14:43
add comment

I've heard liquid nails does a nice job.

share|improve this answer
add comment

I've heard of people using the adhesive for car mouldings to do this. They said its available at most autoparts stores.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.