Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

Using a propane burner, is one of the following methods quicker / more efficient than the other? If so why?

a) Heat 2.82 gallons of water from 70 degrees to boiling and then add 1.12 gallons of 70 degree water to get 4 gallons of 170 degree water.

b) Heat 4 gallons of water from 70 degrees to 170 degrees directly.

share|improve this question
    
where does the other 1.12 gallons of 70 degree water come from - how is that heated and how long does it take/how much does it cost? –  mdma Mar 11 '13 at 1:35
add comment

1 Answer

up vote 4 down vote accepted

If your additional 1.12 gallons of 70F water can be considered free of heating time and cost, then we just need to compare the different quantities of water being heated and the temperature they are raised through:

  • 2.82 gallons from 70F to 212F = 2.82 * (212-70) = 400.44 galF
  • 4 gallons from 70F to 170F = 4 * (170-100) = 400 galF

(I'm using non-standard units - each unit is the amount of energy requried to raise a gallon one degree F.)

In terms of the energy required to heat the water, they are both equivalent requiring 400 units of energy, so they are in principle equal in efficiency and in time taken. Now, I would say that the second approach, heating 4 gallons to 170 is more efficient:

  • the 1.12 gallons you used in the first example, probably isn't free, adding to the energy needed by the first approach.

  • higher water temperatures have higher thermal losses, since there is a larger difference between the water temperature and the environment. Hence, the boiling water will loose more heat each second than the 170F water, requiring more energy, and more time if the same sized flame is used as when heating 4 gallons.

There is one counter-argument that favors the first approach on a practical level in terms of time:

  • if you don't have temperature control on the propane burner, then you may end up reducing the flame to avoid overshooting the 170F target. When heating to boiling, you can turn the burner all the way up and still not overshoot. You will then probably use more energy, since bigger flames are usually less efficient, but it will heat quicker.

To sum up, with the same-sized flame, the 2nd approach, heating all 4 gallons, is the most energy efficient and quickest.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.