Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

took a gravity reading today at the end of the transfer from the kettle and there was quite a bit of trub in the cylinder, like the whole flip'n tube. so would the trub hold the hydrometer up and give a false reading?

share|improve this question
    
It's explained pretty well here –  twospeeder Mar 7 '13 at 22:46
add comment

1 Answer 1

up vote 3 down vote accepted

If the trub is actually physically holding the hydrometer up, preventing it from moving down, then unambiguously: yes, the trub will render your hydrometer reading useless.

If, on the other hand, the trub is suspended in the liquid, it is a mixed bag. Suspended solids will impact a hydrometer reading, but for brewers it is usually very minimal. The only actual measurements I've seen have put the effect at well below even a single point of gravity (thousandths digit on SG scale), though it is conceivable that the effect is more significant in very trub-heavy samples. Still, it's hard to imagine that we'd see an effect of more than a couple of points.

share|improve this answer
    
agreed and with my experience I should know to wait for the trub to settle, but I kinda fell stupid having to leave asap. I came home after work (now) and got an "unobstructed" reading, and it was right where I needed to be. I always wait a day or two for answers but Plus one for now for sure! –  Ryan Shdo Mar 8 '13 at 8:36
1  
@Ryan Shdo - what was the difference between your trubbed reading and your unobstructed reading? –  mdma Mar 8 '13 at 21:43
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.