Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

Can we help our fellow geek solve his homebrew problem?

I'm making a barley wine. My boil gravity should be 1.106. Hydrometer reads 1.042, and at 140°F (60°C) the adjusted SG comes out to more like 1.06. Iodine test says I have all the sugars out.

I mashed 22 pounds (10kg) at 148°F (64.4°C) for 90 minutes, just like the book said. I have collected just about 6 gallons.

Did I sparge too fast? Do I put the wort back into the mash tun and keep it there for X minutes or something? Am I going to have to put LME or DME into the boil?

I will be very unhappy if I [expletive] this up beyond salvaging. Any help you can give me would be much appreciated.

share|improve this question
    
Your boil gravity or your into the fermnter gravity should be 1.106? –  Denny Conn Jan 18 '13 at 1:46
    
Did you take your hydrometer reading at 140 F.? If so, it needs to be corrected since the density of a solution decreases with temperature. There a lot of online calculators to help. –  Tobias Patton Jan 18 '13 at 17:29
    
@TobiasPatton doesn't it say right in the post he adjusted for the temp? –  brewchez Jan 19 '13 at 17:40
2  
Down voted as I am not partial to using one forum to determine an answer from a different website, third hand at that? Maybe if said OP was copying his own question over here. –  brewchez Jan 19 '13 at 17:41

2 Answers 2

You can't (shouldn't) go back to the mash tun after the boil.

My guess is that you would get some tannins instead of more sugar.

As for why you got a lower OG, perhaps it was something on your mash? - Grains crushed too coarsely? - Mash temperature? - Mash style (batch vs fly?)

Since by now you are probably already on the fermentor, there are only 2 things you can do:

1 - Leave it as it is and enjoy a good honest to god beer (probably over 6%)

2 - Add more fermentables to it, either LME, DME or sugars to reach your planned OG, at the risk of the flavor.

I would go with 1 and leave the barley wine for the next batch.

By the way, which book are you following?

share|improve this answer
    
you mean the option 1? –  Paolo Jan 18 '13 at 13:31
    
Meant option 1, corrected. –  Cleber Goncalves Jan 18 '13 at 18:52

1.060 will make a perfectly acceptable beer (albeit not a barley wine), BUT your bitterness to gravity ratio will be way off. The perceived bitterness of a beer is dependent on the starting and finishing gravities. A high gravity beer finishes sweeter than a low gravity beer, and that sweetness reduces the perceived bitterness. If you hopped the beer with the intention of getting a finishing gravity around 1.025 and your beer actually finishes at 1.014, it will be more bitter than you intended.

That's a long winded way of saying that, in order to create a balanced beer, I'd use DME to bring the gravity up closer to your target.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.