Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I have bought a BeerMaker 30 and now I wonder how to do the sparging so that I get the clearest wort possible.

BeerMaker 30

The issue for me is, that I have a steel cylinder that goes into my electric mash/brew kettle. The bottom of the cylinder i a metal plate with holes in it. I suspect that while I do the mashing, some particles will get through there and end up in the brew kettle.

When I am done with mashing, and start sparging I will have a hard time getting all the particles out, since a Vorlauf would be the whole liquid volume.

I am thinking about getting a mash-bag that I could put on the inside of the steel cylinder (or even on the outside).

Am I thinking too complicated? Is this effort really necessary? How would you use this?

I have not yet used this, but I hope to avoid errors that are unnecessary.

share|improve this question
add comment

1 Answer 1

up vote 3 down vote accepted

Just treat it like any other mash tun. Before you pull that thing out of the kettle start drawing off wort through the valve at the base (at least it looks like a valve in the picture). Collect it in a pitcher that you can easily pour from. Then slowly pour in back in at the top of the cylinder. Do this repeatedly until you think the wort looks clear enough. It may take 2-4L of circulation total.

Keep in mind that the wort won't look like clear beer though. It will be cloudy. What you are looking for is that there are no big pieces of grain or husk still coming out. You'll be able to see them as you pour from the pitcher back in.

Good luck

share|improve this answer
    
I think I'll try it...thanks –  Flyhard Nov 22 '12 at 17:34
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.