Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I'm planning to make a Hot Liquor Tank with a 5 gallons cooler and an immersion heater, but I don't have idea about where and which immersion heater I need. I read a tutorial, and the guy is using a 1500 watt heater, but not more information...

Which is your experience with this HLT? And where I could buy the heater?

share|improve this question
add comment

1 Answer 1

up vote 2 down vote accepted

The Electric Brewery is a very popular source for building electric homebrew setups when using steel/aluminum kettles. They sell prebuilt heaters and they also give a list of all the parts they use so that you can buy them separately elsewhere (e.g. Amazon) and put it together yourself:

http://www.theelectricbrewery.com/heating-element-kits

I personally would go this route when using electric heating elements because it's safer. With heating elements inside plastic coolers, you really need to know what you're doing or you could melt it and/or leach chemicals from the plastic if it's not rated for water hot enough. But if you make sure you can keep it in the safe temp range (sparge temps), 1000W or 2000W would be enough to get you to sparge temps.

Camco - the brand the Electric Brewery guy recommends - also makes 1000 watt 120V and 2000 watt 120V heaters.

Or search the web for 'homebrew heat stick' and you'll see lots of other ones. Heat sticks are often used to supplement heat from a stove for full boils and people often want them to plug into 120V outlets in the kitchen, so they don't need to be that powerful.

or a bucket heater like this Allied Precision Bucket Heater (says Marshalltown, made by Allied). Note the bucket heater is not necessarily safe for potable water, though hundreds of homebrewers use it. I used to use it to supplement my boils, but found that it had too many spots that could not be cleaned, so until I can take the rivets out and take the steel shield off, I won't use it anymore for that. But for heating water, it should be ok.

In summary, you can get everything on Amazon. I'm sure you could also get it at a hardware store or plumbing supply store as well.

share|improve this answer
    
The heaters in the website is for kettles, is safe to use with an Igloo cooler? 4500 and 5500 watts? I think is too much power for a 5 gals container... –  Simio Perez Nov 16 '12 at 14:19
    
You're right I didn't realize you said 'cooler', people usually use steel or aluminum with attached heating elements. I revised my answer to include lower power elements. –  paul Nov 16 '12 at 19:41
    
Thanks, I think I'll buy Camco heater... The difference, between 1000 or 2000 watt, is the time to boil the water? –  Simio Perez Nov 16 '12 at 20:37
    
Can I buy the heater at Home Depot? –  Simio Perez Nov 16 '12 at 20:46
    
Yes, the Watts is the amount of power they use/put out, which translates into how much heat they put out. You may be able to find them at Home Depot, but their inventory tends to vary from store to store. Good luck with the wiring! –  paul Nov 20 '12 at 17:55
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.