Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

Yesterday I brewed my first Lager. I chilled the wort to about 72 degrees and figured i should get it colder before pitching. So i got the wort into a carboy and then got the carboy into to the freezer at 50F and left it there overnight. This morning i was about to pitch the yeast but noticed about 3 inches of sediment (is this cold break?) on the bottom of the carboy. At this point i did not know what to do, do i pitch the yeast as is or do i rack the wort to another carboy leaving all that material behind?

share|improve this question
add comment

2 Answers 2

up vote 1 down vote accepted

If you brewed from extract, then it probably is mostly cold break possibly some hop material as well. Even if you chilled in the kettle, it takes time to settle and so it would have been racked along with the wort.

It's not essential, but should you choose to do so you can keep the trub out of the fermentor by whirlpooling the wort in the kettle and leaving it for 15-30 mins until you can see the trub on the bottom of the kettle. Then transfer from the kettle leaving the trub behind.

One problem with so much trub is that it throws off your volume in the fermentor. You think you've got 5.5 gallons - half a gallon for samples and losses in racking, to reach a 5 gallon batch, but later find that a fairly large chunk of that is trub - invisible until it settles out, leaving you with maybe only 5 gallons into primary, meaning you'll probably only get 4.5-4.75 packaged. Not a problem when bottling, but a bit of a waste of capacity when kegging. Keeping the trub out of the fermentor is a big step to getting accurate volume in the fermentor and hitting your intended batch size.

share|improve this answer
1  
I've heard of some brewers who make recipes to a 6 gallon scale, but leave behind a half gal of break material in the kettle, and another half gal of trub in the carboy when bottling/kegging. Thus getting 5 gallons of finished beer. –  Graham Apr 10 '12 at 13:31
add comment

Tests at the homebrew level have shown that there is no benefit to racking off the trub. But it won't hurt, either, if you want to do it. So, the answer is, either way is fine. I'd be inclined to leave it based on the theory that the less you mess with the beer, the better off you are. In addition, I can't think of a major brewer that settles then racks off.

share|improve this answer
    
if there is any settling, it's usually done in the kettle. –  mdma Apr 10 '12 at 6:32
1  
I never bother with the cold break, even in my lagers, and they seem just fine. From what I understand, the cold break provides nutrients to the yeast as well. –  Graham Apr 10 '12 at 13:30
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.