Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I have 1.5lbs of prickly pears and want to make a 2gal all grain batch from them.

My question is how should I add the prickly pears?

Should I smash them and only add the juice?

or maybe

Cut off the skin and add them in secondary?

share|improve this question
    
I ended up putting them in at the end of boil, and all I did to them was cut off the skin. The beer ended up being VERY tart. So much so that is must be drank extremely slowly as if I was drinking a liquor on the rocks. –  corymathews Feb 8 '12 at 20:52
add comment

2 Answers 2

up vote 2 down vote accepted

Not having done this, I can only offer my thoughts and opinions on the subject. I would probably juice and add the juice to the boil (probably as late as possible to pasteurize/sterilize without driving off all volatiles. You'll want to figure the volume and sugar content of juice to add and what your gravity needs to be pre-boil to hit your final post boil volume.

I expect that you'll have a large than normal volume of trub at the bottom of the fermenter after primary so you may want to shoot for a slightly higher initial volume to combat losses in the trub.

share|improve this answer
    
Good advice. I did not even think about the extras after fermenting. –  corymathews Dec 13 '11 at 17:16
add comment

I wouldn't boil them if you like the aroma.

If your adding them to beer:

You should mash them up and add them (with juice) at flame out, whirlpool/sit for a few minutes to pasteurize. I would put the solids in a muslin bag for easy extraction. You can experiment from there, maybe even "dry pear" the finished beer:D I would keep the hops light until you know how this tastes.

If your just making a wine: I would mash them up with a potato masher and fill with water to desired quantity. Then hit it with campden. You should add sugar/honey/etc to hit the appropriate OG. I would put the solids in a bag and remove after fermentation is complete. Make sure to use a yeast nutrient if your not adding malt.

Let us know how this works out!

share|improve this answer
    
Yeah I put them in right at the end of the boil, only had .3 oz of hops for a 2.5 gallon batch and mashed the pears up a bit before adding but I left the entire pears in the fermenter. It fermented well for about 3-4 days and now is just waiting to be bottled in another week. –  corymathews Dec 20 '11 at 14:33
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.