Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I've run out of gas; how can i get the beer out of the keg?

share|improve this question
add comment

4 Answers 4

Put a cobra picnic tap and tubing on a grey gas IN connector and attach it to the gas post.
Attach a longer open ended piece of tubing to the beverage out post.

Lay it on its side with a 2x4 block under the end of it. Lay the keg so that the IN post is down at 6 O'clock and the beverage out post is at 12 O'clock.

Now keep the open ended running above the keg so beer doesn't run out of it. Then you can drain the keg as if it was a cask via gravity. Be careful about hooking up that tubing to the beverage out end. If the keg is charged/pressurized beer will come screaming out of it, so be sure the keg is laying on its side first, and have something to catch what beer might come out initially... I'd suggest a bucket, large glass, or your mouth.

share|improve this answer
add comment

This probably isn't too helpful for your current problem, but they have small CO2 hand-chargers for corny kegs that use small CO2 vials.

This is one option.

I use one with a small picnic tap to bring a keg places without lugging the entire gas cylinder and regulator with me. You just have to be careful to monitor the pressure in the keg by feel. It also comes in handy if I run out of gas and haven't had time to get it refilled.

share|improve this answer
add comment

Similar to brewchez' answer, if you already have a picnic tap with a black beer-out disconnect on a long enough beer line, you should be able to syphon the beer out by filling the beer line and keeping the tap below the level of the beer in the keg. Obviously you'd also need the pressure relief valve open while pouring. You could start the syphon by either filling the beer line with water (or another beer), or sucking on the end of the tap, or gently shaking the keg with the relief valve closed and the tap open.

I've also heard of someone using a soup ladle to scoop beer out of the top of a corny keg, but I'd leave that as a last resort!

share|improve this answer
add comment

I would suggest using an autosiphon. Everything stays upright, and nobody's mouth is on anything. Rest it on the lip of bung until it gets down about halfway and then lower the autosiphon into the bottom. Really what you're looking to do here isn't that much different than racking from a carboy.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.