Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I'm thinking about introducing sambuca (maybe grappa) into my next homebrew. What are the common practices for adding? secondary? bottling? Recommendations for getting the "right" amount without dosing the whole batch?

share|improve this question
add comment

4 Answers

up vote 4 down vote accepted

Put a known volume of beer in tasting glasses or cups. Use measuring spoons to dose each cup with a different amount until you get the level of flavor that you want. Keep notes so that you can do it again. I'm pretty sure that it will scale linearly, so if e.g. an ounce tastes good in 12oz of beer, then around 50oz will taste good in a full (5-gallon) batch. I'd add it to the keg or the bottling bucket, depending on how you intend to serve your beer.

share|improve this answer
add comment

In my experience with adding Bourbon to beer I find it is best done to taste at bottling. This should give you a decent idea of how it will taste after carbonation. I would also recommend having someone help with the tasting since your palate can become fatigued quite quickly.

share|improve this answer
1  
I've had good success adding 1/2 cup bourbon per gallon to my brown ale recipe (at bottling). Very tasty brew. –  Ell Mar 10 '11 at 21:27
add comment

I make a Bourbon Vanilla Imperial Porter that's very popular in the homebrew community. I use both of the techniques described above and it makes it easy to determine the correct amount. I especially agree with having someone else help you with the tasting. I use 2 oz. samples of beer (usually 4 of them) and dose them each with a different measured amount.

share|improve this answer
add comment

I have always done the mini test being careful to note the volumes and ratio as I build the blend in the pint glass.

When I comes time to execute the whole batch I usually would only add 90-95% of what I calculated from my single glass ratio to the whole batch. Then I would taste it and ease up to the final flavor profile I was looking for.

You can always add more but you can't take it away. Its worked well for me in the past. if you are doing it in a keg its real easy because you can purge with CO2 and mix well, then taste it. If you are doing the addition in a bottling bucket I do it prior to adding my priming sugar because that will screw up the tasting a bit. And I gently mix with a long spoon. Maybe there is a lot of oxidation but its fine for me.

share|improve this answer
    
Good call on doing it prior to the priming sugar. I would have thought of it too late. :) –  Bob Banks Mar 10 '11 at 17:34
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.