Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I just started doing a trial run of my first batch and I had a question.

I have a kettle that holds about 6 gallons. If my batch size is to be 5 gallons and we assume 1 gallon will boil off, then this needs to be filled up to the 6 gallon mark after all of the ingredients go in, right?

So I may be only using 4 gallons of water, and the extra volume will be taken up by DME, right (ie., not 6 gallons of water + ingredients, 6 gallons total)?

share|improve this question
add comment

2 Answers

up vote 3 down vote accepted

Seeing how your pot doesn't really seem to be large enough to do what you propose, I would add 4 gallons of water and start heating it. Once you get it hot enough to dissolve the DME, I'd add that in and see ho wmuch room you have left.

A measuring stick of some sort would help here to see it now you are at 4.5 gallons or 5 gallons. The DME will take up some volume depending on how much of it you add obviously. If you know the volume post DME addition, then you can go and maybe top of to 5 gallons or 5.5 in the kettle to give you more volume during the boil off. But I don't think you can go to the full 6 gallons.

Take real careful notes on this batch and then you'll have a good idea of how much water you could start with on the next batch. Worry about accounting for boil off on that batch.

After the boil see how much you have and figure out your boil off rate. Then top off to 5 gallons or whatever you normally shoot for (I used to formulate my extract batches for 5.5 gallons in the fermentor).

share|improve this answer
    
Make sure you take into account the fact that water expands when heated. 5 gallons of 210F water won't be 5 gallons at 70F. Take your volume readings at the same temperature and you should be able to predict your boil off after a few batches. –  Northern Brewer Chris Mar 8 '11 at 18:30
    
Water density only changes by 3-4% at near boiling temps over normal tap water at say 60-70F. I challenge the percision being used to measure the water in the kettle has the same amount of error in it. True we should try to account for it, but we can't blindly state that water expands without being aware of how much and how it relates to our ability to measure it. –  brewchez Mar 8 '11 at 19:20
add comment

Don't forget that you'll need headspace for the hot break, otherwise you'll be risking a boilover. Especially if you're not quick with a skimming device and able to easily control the heat right at pre-boil (remember that electric eyes will carry over a bit).

You might be better off aiming for a 4 gallon batch size or doing a more concentrated boil and topping off with pre-boiled water in the fermentor. You may have to revisit your hop calculations if you do the latter, though.

Unless you're putting tons in, I don't think just DME will add a full gallon to the volume.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.