Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I'm planning a Bavarian Hefeweizen and I read, to keep it real, one should use wort ("speise") to carbonate it. Has anyone got some experience as to how much speise to use or how to calculate an adequate amount?

share|improve this question

3 Answers 3

up vote 2 down vote accepted

A brewer friend of mine does this regularly. I quizzed him about it and he advises pulling 2-3 quarts out of your original 5 gallon batch, into a sanitized jar that sits in the fridge while fermentation takes place.

You can do this right out of the boil kettle, and into a pre-heated glass jar. Top it, let it cool on the counter, and put it in the fridge while fermentation takes place.

share|improve this answer
    
I imagine this technique could be used for any brew, and that the volume of speise would depend on the OG of the batch. It sounds like a great way to save on corn sugar. –  Bill Sep 24 '10 at 16:52
    
This is a great technique to try for fun, but IMO corn sugar cost far out weighs the potential pitfalls of having the speise go bad due to an accidental sanitation issue. –  brewchez Sep 26 '10 at 15:54
    
Thing is if it does go bad in the fridge, you'd know by it clouding or having an off smell. Again, secondhand knowledge, but apparently this has never been a problem for my krausening friend. –  Rich Armstrong Sep 27 '10 at 13:18

Try this link to Kai Troester's wikisite:
Sugar for Carbonation

I can't just post an answer because its dependent upon the temperature of the fermented beer (residual CO2) and the gravity of the speise. I also don't know to what volume of CO2 you want to make the resultant beer.

share|improve this answer
    
In general excellent wikisite. Thanks for the hint. –  Tobi Sep 25 '10 at 7:14
    
Great link, but it is broken for me. Here's the fixed version: Accurately Calculating Sugar Additions for Carbonation –  JesterVineo Jan 17 '12 at 17:04

I don't know how much to use but here's how I would go about figuring it out:

I generally use corn sugar to carbonate, I believe (going off the top of my head right now) it's something like 1 cup of sugar added to 3/4 cup water and boiled to sanitize/dissolve.

So I'd mix the sugar and water together and take a hydrometer reading and then mix up some wort with the same gravity and then mix the same volume (as the sugar water) of that wort into your beer to prime for carbing.

There's probably a way to use math to figure out how what the gravity of the sugar water would be and to figure how much DME to use to reproduce it that reading but I'm not that technical.

share|improve this answer
    
For priming 5 gallons for bottling, it's 3/4 cup of corn sugar. The amount is less for kegging. –  Bill Sep 23 '10 at 21:13

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.