Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

I am building an recirc arm for my chilling set up. Should my recirc have a gentle bend in it to 90degrees or would it be OK to just use a 90degree elbow of a piece of straight pipe under the wort surface?

share|improve this question

2 Answers 2

up vote 6 down vote accepted

I'm not a physicist, but I'd imagine you'd rather have a graceful bend in it. With a 90, I could see the wort slowing down at the bend. If I didn't have flexible pipe from which I could make a gentle bend, I'd consider using two 45's with a small piece in between.

Full disclosure: I don't have a wort chiller; I'm just theorizing.

share|improve this answer
    
Agree.......... –  Dean Brundage Jun 10 '10 at 0:49
    
A HVAC guy once told me that putting a 90 degree bend with a sharp angle takes like 4 times the energy to push air through than a 90 degree elbow that takes a few inches. I'd assume that water in a pipe and air in a pipe act somewhat similar. –  Pulsehead Jun 10 '10 at 12:45
1  
Fluid and air dynamics are quite different though, so I wouldn't really try to compare the two. Think about your house plumbing: most plumbing (at least mine) has a ton of sharp 90 degree bends. –  Room3 Jun 14 '10 at 12:57

A 90 degree elbow would restrict the flow a little bit, but I'm not sure that you would notice any difference. It also depends on the flow you're trying to achieve. Here's a link to a guy that did use a 90 degree arm (not sure if this is exactly what you're trying to do or not). If you're thinking about bending it by hand to achieve the gradual 90 degree elbow, you'll have a much higher risk of restricting the flow by partially flattening out the tube. In my opinion, the 90 degree elbows look a lot cleaner and would provide a little more strength on the joint.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.