Take the 2-minute tour ×
Homebrewing Stack Exchange is a question and answer site for dedicated home brewers and serious enthusiasts. It's 100% free, no registration required.

What do you think would be the best way to try and make 3 5-gallon batches and have them as consistent as possible? I am brewing for a party and want all 3 kegs to be so similar that you wouldn't be able to tell that they weren't a single batch.

share|improve this question
    
thanks for correctng my spelling :) –  Ugly Dude Apr 16 at 16:29
    
you could do 3 different beers! A stout, an IPA and a blonde beer? –  Brad Apr 18 at 18:44

2 Answers 2

up vote 6 down vote accepted

Blend them all together as they go into the kegs. 1/3 of each carboy for 3 kegs.

share|improve this answer
1  
Be sure to taste all the beer before mixing - of one batch has gone bad you'll end up with 15 gallons of bad beer, rather than just 5. –  mdma Apr 14 at 22:43
5  
Hey now, he was going for consistency. ;-) –  Scott Apr 15 at 0:13

You didn't say whether you intend to make them serially or consecutively (edit: oops, I meant concurrently). If you can't make one 15-gallon batch, or blend all three batches together after they're done (very gently, and without unduly exposing them to air) before kegging, temperature control is probably where you want to concentrate. I suggest you keep them all in the same room or the same cupboard—we do what we can, right?—and at the same temperature.

share|improve this answer
    
you are correct, I should have stated that. I do plan to make them all on the same day, but with the answer above, I could conceivably make them on 3 different days, and then mix. of course I wouldnt want too much time to elapse betwen batches :) –  Ugly Dude Apr 16 at 16:31

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.